Double Spirals Jewelry Wire & Beads Bracelet Jewelry Making Project -- Page 6

Step 17:  Now we are ready to make our 2-1 end wire component.  Place pegs 8, 9 and 10 in your jig as shown at right.  We make this 2-1 end wire component using the 3" segments of wire that we cut in the first step.

Step 18:  Place the initial loop in your 3" segment of wire on peg 8 and wrap the wire around peg 9 as shown at left.

Step 19:  Continue by wrapping the wire around peg 10 as shown below left.

Step 20:  Remove your wire from your jig.  The wire component should appear as shown below center-left. 

Step 21:  Cut the excess wire using your flush cutter.  Close the final loop using your bent chain nose pliers.

Step 22:  Using your bent chain nose pliers grasp the wire at the point where the loops made on pegs 8 and 10 begin and bend the wire 90 degrees.  On the initial loop, bend the wire 90 degrees counter-clockwise.  On the final loop, bend the wire 90 degrees clockwise.  When completed the wire component should appear as shown below-right.  Make two 2-1 end wire components using these steps. 

Step 19	Step 20	Step 21	Step 22