Step 9: Now using your round nose pliers. Grasp the loop on either end of the handle wire component and bend it, one at a time, into an eye loop. The technique for doing this is shown here. When done, the handle should appear as shown at right. |
 Step 9 |
| Step 10: Now one at a time, we need to bend these eye loops so that they are perpendicular to the rest of the handle wire component. In the picture at right, you can not see the two loops because they are vertical while the rest of the wire componet is horizontal. |
 Step 10 |
| Step 11: To help make both bend in this wire component as symmetrical as possible, replace the wire component onto the jig as shown at right and bend both loops up until they just barely touch peg 1 or 5. Generally, this requires some bending of the wire on the side that was made second (against peg 4). |
 Step 11 |