|
Step 2: Place your gemstone face down in the finding as shown at right. Step 3: Now hold the finding and gemstone in place between the thumb and forefinger of your non-dominant hand while you use your bent chain nose pliers to press two opposing tabs flat against the gemstone.
Step
4: Finish setting the stone by pressing the opposite pair of tabs
down. With all four tabs pressed down, then re-visit each tab in
turn and gently squeeze it flat against the gemstone. When completed
the setting should appear as shown and
the gemstone will be held securely
Make your second earring using the same steps. Parts Required:
These free jewelry making instructions continue on the next page, page 11. |
Prior Page
Page 10A
Next Page
WigJig Jewelry
Making Tools, Beads, and Jewelry Supplies Home Page SHIPPING
WAIVED ON
ALL ORDERS OVER $60.00 SHIPPED to USA -
More Bling for Less Cha-Ching™ CZ & Gemstone Jewelry Making Projects
Pages:
1 2 3
4 5
6 7 8
9 10
10A
11 12
13 14
15 16
17 18
19 20
21
Jewelry Making Techniques
Beginner's Jewelry Making Instructions
Gemstone Terminology
View our CZs and simulated gemstones and our
jewelry making settings in our Internet store.
See our selection of Beads,
Jewelry Supplies and Jewelry Tools
Customer
Care - WigJig, PO Box 5124, Gaithersburg, MD 20882;
(800) 579-WIRE (phone),
(240) 597-2262 (fax), custsrv@wigjig.com
(email). Privacy Policy.
All content on this
Beads and Jewelry Making Supplies by WigJig web site including
jewelry making and wire
designs are copyrighted© by WigJig. WigJig® is a registered trademark.
Last modified: July 1, 2008